Studer-innotec XTH 3000-12 Manuel d'utilisateur télécharger pdf (Page 29)

Steca Xtender

Installation and Operating Instructions 723.932 Xtender V0.511 Seite 29

10 Figure comment tables

Fig. Description and comment

1a Dimensioning table for the downstream protection device (F). See chap. 4.5.5 – p. 15.

Assembly order for connecting the battery.

The assembly order for the battery connections must be adhered to. Bolts 20 and 21 are

of different sizes: (21): M8x45 for fastening on the fuse

(20):M8x35 for fastening without a fuse

If there is no fuse installed, the two bolts are of identical length: M8x35

The battery clamp fitted on the fuse (24) must have a diameter of M10 in order to match

the centering lip of the ceramic isolation disc.

Ensure that the battery connections are tightened sufficiently.

Dimensions and fastening the device

The support (wall) must be appropriate for supporting the increased weight of the device

without any risk.

Installation distance

Insufficient distance or an increased ambient temperature can reduce the rated power

output of the device.

Battery charge cycle

Charge cycles that are more complex than those described in chap. 6.2.4 – p. 19 of this

manual may be programmed via the RCC-02/03 remote control

Simplified battery charge cycle:

See chapter 6.2.4 - p. 19.

Type plate and series no.

See chapter 13 - p. 34.

The intactness of this label is vital for any possible warranty claims. It must not be altered

or removed.

Device connection box

See chapter 3.6.2 – p. 8.

4b Control table See chapter 7.1 - p. 26.

12 V battery: connection in series and in parallel / series for 2 V cell

12 V battery: connection of 12 V battery in parallel

24 V battery: connection in series and in parallel / series for 2 V cell

24 V battery: connection in series and in parallel / series for 12 V battery block

48 V battery: connection in series and in parallel / series for 12 V battery block

48 V battery: connection in series for 12 V battery block

48V battery: Series connection of 2V cell

48 V battery: connection in parallel / series for 2 V cell

Xtender circuit diagram

Single-phase installation (AC and DC part)

10.1.1

HIS EXAMPLE ILLUSTRATES THE MOST ROUTINELY USED INSTALLATION

ALLOWING THE

ATTAINMENT OF AN EMERGENCY SYSTEM OR A HYBRID SYSTEM

(

REMOTE SITES

)

ENSURING THE SUPPLY IN SINGLE

PHASE FROM A GENERATOR AND

OR THE BATTERY

WHEN THE

SOURCE IS ABSENT

EE ALSO CHAPTER

4.1

RID

CONNECTED

EMERGENCY SYSTEMS

4.1.2 – p. 10.

ON/OFF remote control variants

This example illustrates the various options for connecting the “REMOTE ON/OFF” input

(7), enabling the ON and OFF controls of the Xtender via a contact or a voltage source.

Commentaires sur ces manuels

Pas de commentaire

Studer-innotec XTH 3000-12 Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Studer-innotec XTH 3000-12