Studer-innotec XTH 3000-12 Manuel d'utilisateur télécharger pdf (Page 25)

Steca Xtender

Installation and Operating Instructions 723.932 Xtender V0.511 Seite 25

The features of the RCC-02 and the RCC-03 are the same. They only differ in their external

appearance. The RCC-02 is designed for wall mounting, whereas the RCC-03 is designed as a

tabletop device.

The RCC-03 model must be taken off the table to allow access to the SD card slot (during

updating, for example).

RCC-02: Dimensions: H x W x D / / 58 x 51.5 x 22 mm

RCC-03: Dimensions: H x W x D / / 58 x 51.5 x 22 mm

The two remote control models are delivered with a 2 m cable by default.

Cables of specific lengths (5 m, 20 m and 50 m) can be ordered.

The article no. is as follows: CAB-RJ45-xx. The length in metres is specified as xx

Up to 3 RCC-02/03 remote controls can be connected in series on the communication bus of one

Xtender or an Xtender multi-inverter system. In a system comprising a single Xtender, the

connection of the RCC-02 or RCC-03 may be conducted without stopping the Xtender (warm).

When connecting an RCC-02/03 remote control in a multi-unit system, it is recommended that all

units in the system be stopped and that the communication bus on the device on which the

connection is being made be terminated.

The 2 switches for terminating the communication bus, “Com. Bus" (4) both

remain in

position T (terminated) except when both

connectors are in use. In this case, and only in

this case, both must be placed in the O open position. If one of the two connectors is not

in use, the two termination switches (14) will be in position T.

6.4.2

BTS-01

TEMPERATURE SENSOR

The operating voltages for lead batteries vary depending on the

temperature. A temperature sensor is optionally available to correct the

battery voltage and guarantee an optimum charge whatever the battery

temperature. The correction factor given by the correction of the sensor

is set by the configuration {1139}

Article no. for the temperature sensor (including a cable of 3 m): BTS-01.

Dimensions: H x W x D / / 58 x 51.5 x 22 mm

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Pas de commentaire

Studer-innotec XTH 3000-12 Manuel d'utilisateur Page 25